HW SETUP AND PASSWORDS

User's Manual

3.Use the left/right cursor keys to highlight the boot device you want and press

Enter.

NOTES: 1. If a supervisor password is set, the menu above does not appear when you use the user password to start the computer.

2.The selection method above does not change the boot priority settings in HW Setup.

3.If you press a key other than one of those above or if the selected device is not installed, the system will boot according to the current setting in HW Setup.

4.Support of PC (ATA) card boot is guaranteed only for TOSHIBAPCcardHDDs.

5.A PC (ATA) card takes the position of HDD in the Boot Priority Options list.

HDD Priority Options

If more than one HDD is installed in the computer, this option lets you set the priority for HDD detection. If the first detected HDD has a boot command, the system will boot from the HDD.

Built-in HDD −> PC Card (Default)

HDDs are searched for a boot command in the following order: the built-in HDD, and the PC card. (Default)

PC Card −> Built-in HDD

HDDs are searched for a boot command in the following order: the built-in HDD and the PC card.

NOTE: If a boot command is not found on the first detected HDD, the system will not boot from the other HDD. It will search the next device in the boot priority for a boot command.

Network Boot Protocol

This feature sets the protocol to remotely boot from the network.

[PXE] Sets PXE as the protocol. (Default)

[RPL] Sets RPL as the protocol.

7-8

Page 160
Image 160
Toshiba A40 Series manual Enter, HDD Priority Options