Turning off the power

Data save in hibernation mode

When you turn off the power in hibernation mode, the computer takes a moment to save current memory data to the hard disk. During this time, the Built-IN HDD indicatorwilllight.

After you turn off the computer and memory is saved to the hard disk, turn off the power to any peripheral devices.

CAUTION: Do not turn the computer or devices back on immediately. Wait a moment to let all capacitors fully discharge.

Standby mode

If you have to interrupt your work, you can turn off the power without exiting from your software. Data is maintained in the computer’s main memory. When you turn on the power again, you can continue working right where you left off.

NOTES: 1. When the AC adaptor is connected, the computer will go into Standby mode according to the settings in the TOSHIBA Power Saver utility.

2.To restore operation from Standby mode, press the power button or press any key. The latter action works only if Wake-up on Keyboard is enabled in HW Setup.

3.If the computer automatically enters Standby mode while a network application is active, the application might not be restored when the computer wakes up from Standby.

4.To prevent the computer from automatically entering Standby mode, disable Standby in TOSHIBA Power Saver. That action, however, will nullify the computer’s Energy Star compliance.

CAUTIONS: 1. Before entering Standby mode, be sure to save your data.

2.Do not install or remove a memory module while the computer is in standby mode. The computer or the module could be damaged.

3.Do not remove the battery pack while the computer is in standby mode (unless the computer is connected to an AC power source). Data in memory will be lost.

3-11

GETTING

STARTED

Page 87
Image 87
Toshiba A40 Series manual Standby mode, Data save in hibernation mode