Toshiba e Studio45/35 manual Installing User Software on a Windows Computer

1 Setting up PostScript and/or PCL printing with Windows 95/98/Me

Installing User Software on a Windows Computer

This chapter describes installing software and setting up printing from a Windows-based computer running Windows 95/98/Me, Windows NT 4.0, or Windows 2000.

The general steps for installing the software are:

•Install the PostScript printer driver or PCL printer driver and corresponding printer driver files.

•Set up the printer driver to communicate with the GA-1040.

•Install the Command WorkStation software on the designated Windows 95/98/Me, Windows NT 4.0, or Windows 2000 workstation(s).

•Configure the connection for Fiery Link and the Command WorkStation.

•Setup IPP printing for Windows 2000.

•Copy additional files from the User Software CD as needed.

Setting up PostScript and/or PCL printing with Windows 95/98/Me

To set up the GA-1040 as a PostScript or PCL printer, you must install the PostScript or PCL printer drivers for Windows 95/98/Me and the corresponding printer description files. You can also install the Agfa Monotype Font Manager. Afterwards, you configure the particular type of print connection between the workstation and the GA-1040.

NOTE: Using the PostScript driver requires either the HDD option or the PostScript option installed on the copier.

The following procedure describes using the User Software CD to install the GA-1040 as a local (LPT1) printer. The procedures after that describe completing the print connection for a network printer.