4 Replacement Procedures

4.9 Cover assembly

Installing the cover assembly

The following describes the procedure for installing the cover assembly (See Figure 4-17 to 4-21).

1.Set the WL SW cover to the slot.

2.Set the cover assembly to the base assembly while engaging the latches.

CAUTION: Set the latches of the cover assembly under the guide of the LCD unit.

Guide

Latch

3.Connect the camera/microphone cable and Bluetooth cable to the connector CN9550 and CN4400 on the system board and stick the insulator (HNS HLD KB INSULATOR) in place.

4.Connect the touch sensor cable, power switch cable, volume cable and touch pad SW/LED cable to the connector CN9650, CN3300, CN3330 and CN3240 on the system board.

5.Secure the cover assembly with the following screws.

• M2.5⋅6B

FLAT HEAD screw

⋅6

6.Close the display and turn over the computer.

7.Secure the cover assembly with the following screws.

M2.5⋅2.8B

FLAT HEAD screw

⋅2

(Described as “2.8” in the figure)

M2.5⋅6B

FLAT HEAD screw

⋅7

(Described as “6B” in the figure)

M2.5⋅6C

FLAT HEAD screw

⋅2

(Described as “6C” in the figure)

M2.5⋅16B

FLAT HEAD screw

⋅6

(Described as “16” in the figure)

8.Connect the VGA fan cable to the connector CN8781 on the system board.

9.Connect the TV tuner antenna cable to the connector on the TV tuner.

4-34

[CONFIDENTIAL]

QOSMIO G50 Maintenance Manual (960-683)

Page 264
Image 264
Toshiba G50 manual Installing the cover assembly