4 Replacement Procedures

4.15 LCD assembly/Base assembly

4.15 LCD assembly/Base assembly

Removing the LCD assembly/Base assembly

The following describes the procedure for removing the LCD assembly/Base assembly (See Figure 4-31 and 4-32).

1.Disconnect the wireless LAN antenna cables from the connector on the wireless LAN card and release them from the guides.

2.Disconnect the LCD cables from the connector CN5310 and CN5311 on the system board and release them from the guides.

3.Disconnect the GPS cable or Wireless USB cable from the connector on the GPS or Wireless USB and release them from the guides.

4.Remove the following screws securing the base assembly.

• M2.5⋅6B

FLAT HEAD screw

⋅3

M2.5x6B FLATHEAD

Wireless LAN antenna cable

LCD cable

M2.5x6B FLAT HEAD

CN5310

Wireless LAN card

Guide

 

GPS cable or Wireless USB cable

CN5311

 

GPS or Wireless USB

Guide

Figure 4-31 Removing the base assembly (1)

4-48

[CONFIDENTIAL]

QOSMIO G50 Maintenance Manual (960-683)

Page 278
Image 278
Toshiba G50 manual Replacement Procedures LCD assembly/Base assembly, Removing the LCD assembly/Base assembly