Toshiba manual Troubleshooting the GA-1120, Troubleshooting during Setup from the Control Panel

AA-1 Troubleshooting

Appendix A: Troubleshooting

This chapter provides troubleshooting tips.

Troubleshooting the GA-1120

Startup diagnostics are described in the Installation and Service Guide for service technicians. Contact your authorized service/support center if you see any startup error messages on Command WorkStation or if the GA-1120 does not reach the Idle state.

Troubleshooting during Setup from the Control Panel

The following section explains some error and alert messages you may see during Setup that might not be self-explanatory.

Network Setup messages

After this Setup screen	This message	Means
Enable AppleTalk	No AppleTalk zone found.	The Ethernet network cable is not attached to the
(Network Setup>Protocol		connector on the GA-1120, or the network cable is not
Setup>AppleTalk Setup)		plugged into the hub or network. If your AppleTalk
		network has zones, and you want to specify a zone for the
		GA-1120, you must connect the network cable to the
		GA-1120 before performing AppleTalk Setup.
		Could also mean the AppleTalk network does not have
		zones. Zones are not required for printing to the GA-1120.
		Press Set to continue.
Protocol Setup or Service	You must first enable	Enable at least one network port (Ethernet) in Port Setup
Setup (Network Setup)	a network port.	before beginning Protocol Setup or Service Setup.
Frame Type selection	Invalid frame size.	The network hub is not connected to a Novell machine
(Network Setup>Protocol		when the GA-1120 tries to bind.
Setup>IPX/SPX Setup)
	Warning! IPX network	No other IPX machine can be found on the network, or
	number is zero.	the network hub is not connected to the network when the
		GA-1120 tries to bind. When this occurs, the network
		number defaults to zero.