Toshiba manual Ensuring the copier connection, Proceed to GA-1120 Setup, described in Chapter

33-9 About Setup

NOTE: You must configure the GA-1120 with the correct Windows NT/2000 domain name. This is especially important for Windows printing, also known as SMB printing.

NOTE: The GA-1120 does not support the Windows 2000 Active Directory Service. When you use the GA-1120 in a Windows 2000 server environment, assign the GA-1120 to a Domain or Workgroup.

Ensuring the copier connection

Complete the following steps before you configure the GA-1120 and the workstations that will print to the GA-1120. A service technician will have performed some initial installation.

TO PREPARE FOR GA-1120CONFIGURATION

1.Print a copier test page to verify the copier is functioning normally.

2.Turn off the copier and connect the interface cable from the copier to the GA-1120.

3.To confirm this connection, turn on the copier and the GA-1120, and print a Test Page from the GA-1120 Control Panel.

To print a Test Page, press the Menu button on the Control Panel to display the Functions menu. Choose Print Pages, and then choose Test Page.

4.With both the copier and the GA-1120 turned off, connect the network cable to the GA-1120, as described in Chapter 1.

The network should already be installed and operational.

5.Turn on the copier and then the GA-1120.

Proceed to GA-1120 Setup, described in Chapter 4.