Toshiba Connecting network cable to the GA-1120, Back view of the GA-1120 Illustration TBD

11-10 Connecting to the Network

Connecting network cable to the GA-1120

In this section, the back panel of the GA-1120 is illustrated, followed by information for connecting to the Ethernet board.

Back view of the GA-1120

Illustration TBD

RJ-45 Ethernet (10/100Base T)

Not used

Ethernet connection

For Ethernet connections, the GA-1120 supports Unshielded Twisted Pair (UTP) cabling, defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs into the RJ-45 socket on the GA-1120.

NOTE: The 100BaseT type supported by the GA-1120 is 100BaseTX, also known as Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term “100BaseT” is used to refer to 100BaseTX.

TO CONNECT TO THE ETHERNET BOARD

•Connect the network cable to the RJ-45 connector on the back of the GA-1120.

You must use a Category 5 unshielded twisted pair cable network cable for 100BaseT.