Toshiba GA-1120 manual TCP/IP Setup with Ethernet, TCP/IP Ethernet Yes/No Yes, Select protocol

44-17 Network Setup options

TCP/IP Setup with Ethernet

Network Setup

Protocol Setup

TCP/IP Setup

Ethernet Setup

TCP/IP - Ethernet

Yes/No [Yes]

Select Yes if you have a TCP/IP network connected to the GA-1120 over Ethernet cabling.

NOTE: If you are using TCP/IP for printing from Windows computers, enabling

TCP/IP here also enables you to use Fiery utilities from Windows computers using

TCP/IP protocols.

Enable Auto IP Config

Yes/No [Yes]

Select Yes to allow the GA-1120 to obtain its Ethernet IP address by searching the network. Depending on your network and the protocol you select in the following option (DHCP, BOOTP, or RARP), the IP address can change. Select No to assign the GA-1120 a static IP address that will not change. If you select No, you proceed to the IP Address option, where you manually set the IP address.

Select protocol

DHCP/BOOTP/RARP [DHCP]

This option appears only if you answered Yes to Enable Auto IP Config. Select the protocol over which the GA-1120 should search for its IP address. Both DHCP and BOOTP allow the GA-1120 to obtain the Ethernet IP address and Subnet Mask automatically. RARP obtains only the Ethernet IP address.

Depending on your network, the GA-1120 might be assigned a different address after you restart the GA-1120. With the DHCP setting, the GA-1120 can be assigned a different address even if it is not restarted. Make sure the network is already configured properly for the protocol you select.