2 SENDING A FAX
yECM (Error Correction Mode):
ECM (Error Correction Mode) is an internationally standardized communication mode that automatically corrects errors that occur during Fax transmissions. Even when the transmit- ted data has been affected by noise during communication, this mode allows good communi- cation without image distortion by automatically resending the part that has been affected.
ON, OFF
*Both the transmitter and the receiver must have the ECM function to make ECM communication available. When affected by noise during communication, communication time takes longer than usual.
yQuality TX:
Set whether or not to specify Quality TX. This function makes the communication less affected by line condition when transmitting document to overseas. When this mode is set to “ON”, originals are sent at a slower speed than normal.
ON, OFF
yLine:
Specify the line to be used when you send the original. This option is only available when the 2nd line option is installed.
( P.162 “2nd Line Board (optional) Installation”) OFF, LINE1, LINE2
ySUB/SEP, SID/PWD:
Input the
SUB | Entering information |
SEP (selective polling address): | Retrieving information |
SID (sender identification): | Password for SUB |
PWD (password): | Password for SEP |
*Up to 20 digits of information can be stored for each of these
When you send documents, you can specify a
*To use this function, the remote Fax must be capable of setting an
ySubject, Body:
Subject and body can be added when using the Internet Fax function.
*When originals are placed on the original glass, you can change the following scanning conditions
for each page. ( P.37 “Setting the scanning conditions for each page”) Resolution Original mode
Exposure Original size
* Changing the default settings (HOME POSITION) when sending originals. ( P.152 “Setting the Initial Transmission Mode”)
