Configuring Routing
This chapter assumes that routing software has been installed, and that an initial set of routing rules have been defined.
This chapter explains how to configure a routing system. The following table lists the configuration tasks described in this chapter.
Configuration Task | Performed By | See | |
Page… | |||
|
| ||
|
|
| |
Set up Imaging destinations | All sites involved | 26 | |
|
|
| |
Set up DICOM destinations | All sites involved | 37 | |
|
|
| |
Review/edit route priors logic | Sending site | 40 | |
|
|
| |
Image Gateway configuration | Sending site | 42 | |
|
|
| |
Routing Gateway configuration | Sending site | 43 | |
|
|
| |
Import routing rules | Sending site | 44 | |
|
|
| |
VistARad site parameter setup | Sending site | 47 | |
|
|
| |
VistARad workstation setup | Receiving site | 48 | |
|
|
| |
Alter configuration in response to | All sites involved | 50 | |
changes in routing system | |||
|
| ||
|
|
|
A configuration checklist is also available in Appendix A.
April 2006 | VistA Imaging V. 3.0, Patch 18 | 25 |
