Configuring Routing

Routing User Guide

 

 

Routing rules:

SEND(IMAGPROVIDER1)

If: MODALITY=CT

SEND(IMAGPROVIDER2)

If: MODALITY=CR

SEND(BAL2)

If: MODALITY=XA

Priority: HIGH

Press <Enter> to continue...

4After the rules are displayed and double-checked, press Enter to return to the menu.

Re-Importing Routing Rules

To be change routing rules, Route.dic will need to be modified, and then re-imported. When routing rules are re-imported:

ƒThe existing routing table will be replaced. Retaining the original set of rules in a backup file allows you to restore the routing table, if necessary.

ƒIf you are using load balancing, importing routing rules will cause internal counters that control load balancing to be reset. For more information, see page 13.

ƒIf multiple Routing Gateways are present, the steps for importing the modified rules file must be performed for all Routing Gateways, so that Gateways will all use the same set of rules.

Routing Rules & Multiple Routing Gateways

If multiple evaluation processors need to be active (as could be the case at a consolidated site) each Routing Gateway can use its own local set of rules.

However, it is usually better for all Routing Gateways to use a single set of rules stored in a shared directory. Using the same set of rules will make maintenance easier (changes to rules need to be made in only one Route.dic file, rather than several), and allows each gateway in the pool to function as a backup for any other gateway.

46

VistA Imaging V. 3.0, Patch 18

April 2006

Page 54
Image 54
Vista Imaging Vista Routing manual Re-Importing Routing Rules, Routing Rules & Multiple Routing Gateways