Vista Imaging Vista Routing manual Starting the Transmission Processor

Using the Routing Gateway Routing User Guide

5Position and size the terminal window for subsequent monitoring. (Note that no new information will be shown in the terminal window until the evaluation processor encounters entries in the rule evaluation queue.)

Starting the Transmission Processor

1Open a new terminal window and log into the DICOM Gateway software.

2Enter 3 to select “Routing Gateway” from the DICOM Gateway Menu [MAGDMENU].

3Enter 1 to select “Start the Transmission Processor.”

4A list of destinations will be displayed. To select all possible destinations, enter an asterisk (*). To enter a partial list, follow the instructions at the prompt.

Possible destinations are:

125:KANSAS at \\TELERAD3\wichita

152:ST LOUIS CR at \\vhastlvistarad

164:IMAGPROVIDER1 at C:\REMOTE\IMAG1\

166:LEAVENWORTH, KS at C:\REMOTE\LVW\

167:IMAGPROVIDER2 HOME at C:\REMOTE\IMAG2\

168:ST. LOUIS, MO at C:\REMOTE\STL\

Select destinations by:

==> Enter their number(s), separated by commas

==> Enter an asterisk (*) to select all possible destinations Prefixing an entry with a dash deselects the listed destinations

Enter a period when the selection is complete.

---> *

5The destinations you selected will be displayed. Enter a period when you are finished.

6Position and size the terminal window for subsequent monitoring.

ÂAs the transmission processor sends exams to Imaging destinations, it will map and un-map certain drives. For more information, see page 66.

7To start additional transmission processors, repeat steps 1 – 6 in a new terminal window.

52 VistA Imaging V. 3.0, Patch 18 April 2006