VTech IP8300 user manual To one minute for this to take place

Troubleshooting

Problem	Suggestion
	��	If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your
		telephone lines, you must have a DSL filter between the telephone base and the telephone wall
		jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please
		contact your DSL service provider for more information about DSL filters.
My cordless handset	��	Make sure the power cord is securely plugged into the telephone base. Plug the telephone
beeps and is not		base into a different working electrical outlet not controlled by a wall switch.
performing normally.	��	Move the cordless handset closer to the telephone base. It may be out of range.
	��	Reset the telephone base by unplugging the base power adapter. Wait for 15 seconds and
		plug it back in again. Allow up to one minute for the cordless handset and the telephone base
		to synchronize.
	��	Other electronic products can cause interference to your cordless telephone. Try installing
		your telephone as far away from these electronic devices as possible: wireless routers, radios,
		radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal
		computers, kitchen appliances and other cordless telephones.
Common cure for	��	If the telephone is not responding normally, trying putting the cordless handset in the charger.
electronic equipment.		If it does not seem to respond, try the following (in the order listed):
	�� Disconnect the power to the telephone base.
	�� Disconnect the battery from the cordless handset.
	�� Wait a few minutes before connecting power to the telephone base.
	�� Re-install the battery and place the cordless handset into the charger.
	�� Wait for the cordless handset to synchronize its connection with the telephone base. Allow up
		to one minute for this to take place.
		www.vtechphones.com	98

Appendix