Watlow Electric EZ-ZONE PM 8Chapter 8: Factory Page, Navigating the Factory Page, Home, Page, Note:, Factory Page, If there is only one instance of a menu, no submenus will appear

8Chapter 8: Factory Page

To go to the Factory Page from the Home Page, press and hold both the Advance ‰ and Infinity ˆ keys for six seconds.

•Press the Advance Key ‰ to move through the parameter prompts.

•Press the Up ¿ or Down ¯ keys to change the parameter value.

•Press the Infinity Key ˆ to return to the Home Page.

Note: Avoid continuous writes within loops. Excessive writes to EEPROM will cause premature EEPROM failure. The EEPROM is rated for 1,000,000 writes.

Navigating the Factory Page

Note:

Home
Page	Factory Page	Parameters
[~~p~]ˆ [CUST]ˆ[```I]ˆ
			

[~~Sp]‰ˆ[FCty]‰[CUST]‰[`PAr]‰[`iid]‰

Some of these menus and parameters may not appear, depending on the controller's options. See model number information in the Appendix for more information.

If there is only one instance of a menu, no submenus will appear.

Hold both keys	Custom	Custom 1	Parameter	Instance
for 6 seconds.	Menu	Submenu
	<
	>
	ˆ Custom 2		Same as above.
		to 20
		Submenus
ˆ[`LoC]ˆ 					
	[FCty]‰[LoC;o]‰[LoC;P]‰[rLoC]‰[SLoC]‰
	Lockout	Lock	Lock	Read Lock	Set Lock
	Menu	Operations	Profiling
	<	Page	Page
	>
ˆ[diAg]ˆ 											
	[FCty]‰[``Pn]‰[`rEu]‰[S;bLd]‰[``Sn]‰[dAtE]‰[USr;r]‰[USr;S]‰[iP;A1] … [iP;A4]‰[C;LEd]‰
	Diagnostic	Part Number	Software	Software	Serial	Date of	User Restore	User Save	IP Actual	IP Actual	Communica-
	Menu		Revision	Build	Number	Manufacture	Set	Set	Address	Address	tions Indica-
	<								Part 1	Part 4	tor Light
	>
ˆ[`CAL]ˆ[~~~I]ˆ
							
	[FCty]‰[`CAl]‰[`Mu]‰[ELi;o]‰[ELi;S]‰[ELo;o]‰[ELo;S]‰
	Calibration	Calibration 1 Electrical		Electrical	Electrical	Electrical	Electrical
	Menu	Submenu	Measure-	Input Offset	Input Slope	Output	Output Slope
	<	<	ment			Offset
	>	>
	ˆ Calibration 2		Same as above.
		Submenu

Watlow EZ-ZONE®PM Integrated Controller • 49 • Chapter 8 Factory Page