Wegener Communications 6420 user manual Appendix 1 Terminal Commands, Terminal Command Listing

iPump 6420 User’s Manual

Appendix 1: TERMINAL COMMANDS

Terminal Command Listing

Note, this list in process of cleanup.

Complete Listing of Available Diagterm Commands:

Command - dec 1 audiosamplerate: Sets the output audio sample rate for the decoder

Command - dec 2 audiosamplerate: Sets the output audio sample rate for the decoder

Command - dec 3 audiosamplerate: Sets the output audio sample rate for the decoder

Command - errors: type threshold - Set alarm threshold type: 'E' for Errored Seconds or 'C' for Continuity Errors

(C is not supported in this release) threshold: Threshold when to decalre an alarm

Command - HTTP PROXY addr: proxy_ip_addr Sets/displays the HTTP Proxy Address

Command - HTTP PROXY enabled: 01 Disables/Enables the use of the HTTP proxy info

Command - HTTP PROXY port: proxy_port Sets/displays the HTTP proxy port

Command - ifconfig: Displays the current ethernet device(s) configuration

Command - ipconfig: Displays the current ethernet device(s) configuration

Command - lan gateway: Sets the network gateway for the LAN interface

Command - lan ip: Set the unit's static LAN IP Address

Command - lan mode: Sets the LAN addressing mode. DHCP, STATIC

Command - lan setup: [ip] [subnet] Sets up IP address and subnet mask for the LAN port

Command - lan subnet: Sets the unit's static LAN Subnet Mask

Command - localtimezone: Set or display the local timezone. To set: Parameter must be a path to an exisitng binary zoneinfo timezone relative to the zoneinfo top-level directory.

Command - margin: margin_offset - Set SNR margin offset

Usage: MARGIN margin_offset
margin_offset Range: 1.0 - 10.5 dB
Command - MODEM passwd: passwd		Sets the PPP password
Command - MODEM phone: number		Sets the dialout phone number
Command - MODEM prefix: string	Sets the dialout phone number prefix
Command - MODEM user: name	Sets the PPP user name

Command - net dhcpupdate: Tell devices in DHCP mode to poll for DHCP connection

Command - net dns: [primary] [secondary] Sets the primary or secondary dns servers

Command - net forcedns: Force specified dns servers to take precedence over dhcp dns

servers
	Command - OAR report: Status of Current Active Recording
	Command - port: [number]>	Select RBDS port
	RBDS Command:
	Select RBDS DB9 connector
	sets DataRate {Databits,Parity,Stopbits}.
	www.wegener.com	800070-01 Rev B	Appendix 1, Page 109