Wegener Communications 6420 user manual Supplied for two main audios

		iPump 6420 User’s Manual
Characteristic	Specification
File selection keywords	1)	SHUFFLE—select files to play from folder such that
(used in any file-play		each plays once before any repeat, but order is
specification for an insert)		different each time through
	2)	RANDOM—select files to randomly play from folder,
		but without any repeats
	3)	SEQUENTIAL—Like SHUFFLE, but maintains same
		play order each time through file list in folder
Insertion “Profiles”	1)	Pre-silencemutes live for programmable period
		before file insert starts
	2)	Post-silencemutes live for programmable period after
		file insert ends
	3)	Programmable attenuation of file audio during insert
	4)	“Duck” allows live to mix with file audio during insert
		at programmable attenuation
Transitions on file	Seemless. No inserted silence.
insertions
Synchronization of inserts	1)	Compel NETCON DELAY
to live audio track	2)	Compel Extended Syntax command delay
Analog Audio Output	Measured at 256 kbps audio ES rate, stereo mode
Output Level-MAX PPL	+18.0 dBm into 600 ohms @ 0 dB attenuation
	+24.0 dBm is optional
Output level adjust range	0 to 20 dB attenuation in 1 dB steps from Output Levels
	above
Output Impedance	Balanced: < 60 Ω
Frequency Response	20Hz to 20 kHz, + 0.5/-1.5 dB
	50 Hz to 15 kHz, ± 0.5 dB
Phase Accuracy	50 Hz to 15 kHz, ≤ ±2° from linear phase
SNR	≥ 88 dB (22 Hz to 20 kHz) unweighted
Harmonic Distortion	< 0.1%
(1KHz test-tone, 1dB below PPL)
Dynamic Range	16-Bit Delta Sigma DAC
Muting	Muting control of each Audio Decoder (port) is available,
	muting both analog & digital outputs in tandem
Digital Audio Output	Supplied for two main audios
Protocol	Balanced 16-bit AES3 audio,
	Sample rate per each audio output
Output Impedance	Differential pair, 110 ohms
Output level	Non-adjustable 5 VP-P
Muting	Muting control of each Audio Decoder (port) is available,
	muting both analog & digital outputs in tandem

www.wegener.com 800070-01 Rev B Chapter 1, Page 15