Wegener Communications user manual IPump 6420 Specifications, LNB DC Power

iPump 6420 User’s Manual

1.4.iPump 6420 Specifications

Characteristic		Specification
DVB-S1-QPSK Tuner
RF Input
Input Impedance		75 Ω unbalanced
Input VSWR, 75 Ω system		< 2:1 (9.0 dB R.L. min), 950-1450 MHz
		< 3:1 (6.0 dB R.L. min), 1450-2150 MHz
Surge Resistance		Survives up to 10 direct-coupled 8kV discharges (per IEC
		801-2)
RF Tuning
Input Frequency Range		950 to 2150 MHz
LO Leakage at Input		< -50 dBm
Symbol-rate Range		2 to 45 Msps (may be limited by Transport Rate Limits)
Tuning Resolution		10 kHz
Input Signal Level Range		-25 to -65 dBm
Signal Level Warning		Warns within +10/-5 dB of upper limit and +5/-10 of lower
Limits		limit
Maximum Aggregate Input		-8 dBm min
Power
Demodulator/FEC
Modulation		QPSK (α=.35) per DVB (EN300 421)
Carrier acquisition range		+1 MHz or +10% of symbol-rate QPSK, whichever is greater
Max Eb/No @ Quasi-		Per EN300 421:
error-free threshold (less		QPSK R=1/2: 4.5 dB,
than one uncorrected		QPSK R=2/3: 5.0 dB,
error-event per hour)		QPSK R=3/4: 5.5 dB,
		QPSK R=5/6: 6.0 dB,
		QPSK R=7/8: 6.4 dB,
RF Power Level Estimator		Unitless metric SIGNAL corresponds to input power as
(locked to carrier or not)		follows:
		Above -25dBm: Extrapolated up to 100+
		-25dBm:	90	-55dBm:	30
		-35dBm:	70	-65dBm:	10
		-45dBm:	50	no signal <0
		Below -65dBm: Extrapolated from 10 down to <0
		Accuracy: unit to unit <+5 dB; over frequency <+10 dB
LNB DC POWER		(supplied on RF center conductor)
Activation		User or network controlled selectable: ON or OFF
Voltage		~ +18.7 VDC nominal at no loading, +18.0 VDC min. at max
		loading
Current (full load)		350 mA max.
Short circuit protection		Thermal fuse, tripping at ~500 mA.
European “Universal		Implements LNB polarization & frequency-band control, per
LNB”		ASTRA recommendation
	www.wegener.com	800070-01 Rev B			Chapter 1, Page 13