Wegener Communications 6420 user manual Default LCD Screen, Front-panel Menu structure

iPump 6420 User’s Manual

Default LCD Screen

No matter where a user may be in the LCD menu hierarchy, if no front-panel keypress is made for more than a factory-set time (typically ~5 minutes), and if the screen is not “parked”, then the LCD menu state reverts to the default screen.* The default screen is always a “Top Level” screen. Typically, this is the “Home Screen”. Layout of the Home Screen is given in Figure 2-3in Section 2.5.

*See User Controls.

Front-panel Menu structure

Table 3-1shows the current menu structure for the iPump6420 Front-panel interface. If local control is disabled, some of these screens may be hidden.

Table 3-1: i6420 Front-panel Menus

Main Level	Second Level		Third Level	Fourth Level	Fifth Level
Home Screen
Download
Screen(if
applicable)
Alarm/Warning	Current Alarms
(if applicable)	(if applicable)
	Current Warnings (if applicable)
	Clear Indications	(if applicable)
Request DHCP
Update
Unit Setup	Decoder Setup		Decoder Number n: (n
			= 1,2 OR 3)
			Decoder Setting
			Select:	OFF	Program Number :
				PROGRAM
				FOLLOW TUNE	Port Number:
				LAN UNICAST
					ACTIVATE?
					<Yes/No>
					MULTICAST
				SAT MULTICAST	Addr :
					Port Number:
					ACTIVATE?
					<Yes/No>
					MULTICAST
				LAN MULTICAST	Addr :
					Port Number:
					ACTIVATE?
					<Yes/No>
	Audio Setup		Decoder Number n: (n
			= 1,2 OR 3)
			Audio Lang Setting:
			(if Availlable)	<Availlabel Lang list>
			Audio Routing	Stereo
				Left on Both
				Right on Both
				Reverse Stereo
www.wegener.com			800070-01 Rev B	Chapter 3, Page 62