Freedom SW 3K2K InvChg Owners Guide.book Page 12 Wednesday, October 9, 2013 1:34 PM
Freedom Inverter/Charger Operation
Inverter Operation Using the Front Panel
IMPORTANT: Review the “Important Safety Instructions” on page iv before operating the inverter/charger.
Once the inverter/charger is installed, you can operate it in invert mode.
To operate in invert mode from the front panel:
1.Press the INVERTER ENABLE button on the Freedom SW on the front panel. The INVERTER ENABLED LED illuminates and connected loads will be energized.
2.Note that if AC is present and being passed through, the INVERTER ENABLED LED will still illuminate to indicate inverter mode has been enabled. However, AC will continue to be passed through to the loads until conditions exist that cause AC to be disqualified, in which case the unit will transition to invert mode and power up critical loads.
3.Connect AC input power.
The charger automatically starts up when qualified AC power is connected.
To operate the inverter with the System Control Panel, refer to “Operating the Freedom SW with the SCP” on page 15.
4.Disconnect AC power from inverter input by opening the breaker or disconnect.
5.Place a load on the inverter. For example, plug a
6.To test the charger, reconnect the AC input power to allow AC to the AC input. The AC/Charger On LED should start flashing after a brief delay. Any AC loads previously powered by the inverter will also work at this time.
NOTE: On dual input models, only AC Input L1 needs to be powered for the unit to operate.
7.Remove the AC input power. The inverter/charger should transfer to invert mode immediately. (The transfer relay will make a clicking sound and the INVERTER ENABLED LED will illuminate.) Loads should continue to operate uninterrupted.
If any part of this test fails, determine the cause before using the unit.
8.Monitor the Freedom SW Front Panel.
The indicator lights on the front panel show you the operating status of the Freedom SW. A description of the lights is provided in Table 1.
If none of the front panel lights are on, see “Troubleshooting” on page 65.
Table 1 Front Panel Lights
Light |
|
|
|
Illuminated | Color | Status | Action (or Status Item) |
|
|
|
|
INVERTER | Steady | If utility and generator AC is | You can run your appliances |
ENABLED | Green | unavailable and operating | from the inverter. |
|
| conditions are met, the |
|
|
| Freedom SW will produce |
|
|
| AC voltage to power loads. |
|
GEN SUPPORT | Flashing | The inverter is assisting a | You can run your appliances |
| Green | generator in powering loads. | from the inverter. |
|
| 12 |
|
| Freedom SW Owner’s Guide |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|