Freedom SW 3K2K InvChg Owners Guide.book Page 10 Wednesday, October 9, 2013 1:34 PM
Freedom SW Inverter/Charger Mechanical Features
1 | 2 |
|
| 3012 |
|
CLEAR | FAULT |
|
|
|
|
| |
| RESET | INVERTER |
|
|
| ENABLE |
|
|
| FREEDOM | SW |
|
|
| |
|
|
| 3012 |
9 | 8 | 7 | 6 | 5 | 4 | 3 |
XANBUS INTERFACE | STACKING | CLEAR FAULT | INVERTER |
|
|
|
|
| RESET | ENABLE |
|
|
|
|
|
|
| INVERTER |
|
|
|
|
|
| ENABLED | AC IN | FAULT |
|
|
|
| GEN | CHARGING WARNING | |
|
|
|
| SUPPORT |
|
|
|
| FREEDOM SW | INVERTER/CHARGER | |||
Item | Description |
1DC terminals.
2AC wiring compartment access panel with compartment cover on.
3FAULT LED illuminates solid if a fault condition occurs and flashes intermittently when a WARNING condition is active.
4When AC is present and qualified, the AC IN LED will illuminate solid indicating also that AC is passing through.
CHARGING LED flashes intermittently when the Freedom SW is in charge mode and is producing DC output to charge your batteries.
5INVERTER ENABLED indicates the invert mode is enabled. This is different from the inverter being “on”. When enabled the inverter can be on or off. When disabled, the inverter is always off. If AC is present and invert mode is enabled, this LED remains illuminated even though AC power is being passed through.
GEN SUPPORT LED flashes intermittently when the inverter is in generator support mode and is assisting the generator.
6INVERTER ENABLE button is used to enable or disable the inverter.
7CLEAR FAULT RESET button is used to clear any active faults if pressed momentarily. If held down for more than three seconds, the unit will reset (reboot) itself.
8STACKING port is used to connect two inverter/chargers together for stacked operation. This is required only for stacking in series.
9XANBUS INTERFACE ports are used to connect
Figure 4 Isometric View of the Front Panel and AC/DC Side Panel
|
| 10 |
|
| Freedom SW Owner’s Guide |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
