Freedom SW 3K2K InvChg Owners Guide.book Page 57 Wednesday, October 9, 2013 1:34 PM
Configuring the Freedom SW using the SCP
Resetting the Freedom SW to
Default Settings
The Restore Defaults command returns the Freedom SW to factory default settings. After using the Restore Defaults command, the Freedom SW is no longer configured for the power system.
To restore Freedom SW default settings:
1.On the Advanced Setup menu, select Restore Defaults. Warning W252 appears, asking to confirm the command.
2.To cancel the command, press Func. To continue with the
Restore Defaults command, press Enter.
IMPORTANT: If a warning is already active in the system, selecting Restore Defaults brings up the Warnings list, with warning W252 at the top. Press Enter to view W252 and continue with the restore defaults process.
EQUIPMENT DAMAGE
Do not restore defaults while the Freedom SW is operating.
Failure to follow these instructions can damage the unit and/or damage other equipment.
Using the Advanced Features
FSW3012 00: Adv Features
NoLoadVD | [Disabled] | [*Disabled] [Enabled] |
Follow procedures on “To select and change a configurable setting:” on page 33 to change the settings.
Figure 31 Adv Features Menu Screen
Table 18 Adv Features Description and Valuesa
Item | Description | Default | Range |
|
|
|
|
NoLoadVD | When enabled, power save | Disabled | Disabled, |
| mode can reduce tare loss |
| Enabled |
| from the battery by reducing |
|
|
| output from 120 volts to 110 |
|
|
| volts when the loads are less |
|
|
| than 100 watts. When the |
|
|
| Freedom SW detects loads |
|
|
| higher than 100 watts, it |
|
|
| produces the full 120 volts. |
|
|
|
|
|
|
a. Applies to all Freedom SW models.
57 |
