Freedom SW 3K2K InvChg Owners Guide.book Page 56 Wednesday, October 9, 2013 1:34 PM
Configuring the Freedom SW using the SCP
Setting the Device Number
Setting the device number gives a
A device number consists of two digits ranging from 00 (default) to 31.
If only one of each type of device is installed in the network, you do not need to set the device number. However, setting the device number to a value other than 00 is recommended in case you need to use the Restore Defaults command (which resets the device number to 00). After performing the command, checking that the device number has returned to 00 indicates that the command was successfully completed.
To set the Freedom SW device number:
1.On the Freedom SW Setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the
Setup menu, display Advanced Settings by pressing Enter + Up arrow + Down arrow simultaneously.
On the Advanced Settings menu, select Stacking and press Enter.
2.On the Stacking menu, select Dev Number.
3.Press Enter to highlight the instance number.
4.Use the up and down arrow buttons to adjust the
5.Press Enter.
FSW3012 00: Stacking |
| FSW3012 00: Stacking | ||||
Dev Name | [00] |
| Dev Name | [00] | ||
Dev Number | [01] |
| Dev Number |
| [*01] |
|
Stack Mode | [1Ph Master] |
| Stack Mode | [1Ph Master] | ||
|
|
|
|
|
|
|
3 | 5 | ||
|
| 4 | |
| FSW3012 00: Stacking | ||
| Dev Name | [00] |
|
| Dev Number | [01] |
|
| Stack Mode | [1Ph Master] |
Steps 1 and 2 are not shown.
Figure 30 Setting a Device Number
|
| 56 |
|
| Freedom SW Owner’s Guide |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|