Xantrex Technology 815-3012 Operating the Freedom SW with the SCP, 97-0019-01-01, State Mode

Freedom SW 3K2K InvChg Owners Guide.book Page 27 Wednesday, October 9, 2013 1:34 PM

Operating the Freedom SW with the SCP

Table 4 Freedom SW Device Setup Screen Operating States (Modes)

State (Mode)	Displayed When...
Invert	The Freedom SW is supplying power to loads by inverting power
	from the batteries. AC input from the utility or generator is absent or
	out of nominal range.
Qualifying AC	The Freedom SW is determining if AC input is within a usable
	voltage and frequency range. Qualifying AC is also displayed
	when the Freedom SW is awaiting application of AC power or a
	command to enable invert mode.
Charging	The Freedom SW is charging the batteries from qualified AC input
	from the utility grid or a generator. The charge state is in transition
	to either bulk, absorption, float, or equalize. AC input is also passed
	through to the load while charging.
Bulk	The Freedom SW is bulk charging the batteries from qualified AC
	input from the utility grid or a generator. AC input is also passed
	through to the load while bulk charging.
Absorption	The Freedom SW is absorption charging the batteries from qualified
	AC input from the utility grid or a generator. AC input is also passed
	through to the load while absorption charging.
ABS Finish	One Freedom SW unit has completed the absorption stage and is
	waiting for other Freedom SWs in the system to complete
	absorption. This status can occur only when there is another
	Freedom SW also charging the battery.
Float	The Freedom SW is float charging the batteries from qualified AC
	input from the utility grid or a generator. The Freedom SW is set for
	three-stage charging. AC input is also passed through to the load
	while float charging.
Fault	The Freedom SW has an active fault. The Fault/Warning light on the
	Xanbus SCP is on.

State (Mode)	Displayed When...
Gen Support	There is AC input from the generator, and the Freedom SW is
	supporting the generator by supplying additional power to the
	critical loads. See “Gen Support” on page 53.
Search	Search mode is enabled and the Freedom SW is standing by, waiting
	to begin inverting. See “Changing Configurable Settings From The
	Device Setup Menu Screen” on page 32.
Passthru	The AC connected to the AC1 or AC2 input is passing directly
	through the Freedom SW to the loads. The batteries are not being
	charged in this state.
Equalize	Equalization has been turned on and the Freedom SW is equalizing
	the batteries after completing a full charge cycle.

97-0019-01-01 27