Freedom SW 3K2K InvChg Owners Guide.book Page 26 Wednesday, October 9, 2013 1:34 PM
Operating the Freedom SW with the SCP
|
| Field 1 | |
| Field 2 | Field 3 | Field 4 |
Line 1 FSW3012 00: Setup |
|
| |
Line 2 Mode |
| Invert | |
Line 3 Battery | 11.9V | N/A | |
Line 4 Load | 915W | 120V | 7A |
Line 5 |
| 60Hz | |
Field 5 |
|
|
|
Field 6 |
|
|
|
Field 7 |
|
|
|
| Field 8 | Field 9 | Field 10 |
Table 3 Device Setup Screen Status Information
Line 4 | Label: Load |
| Field 5: Total power drawn by AC loads connected to the unit. |
| Field 6: Inverter output voltage at load terminals of one inverter/ |
| charger unit. |
| Field 7: Sum of all current drawn out by the AC loads. |
|
|
Line 5 | Label: AC In |
| Field 8: AC input voltage at AC In terminals of the inverter/charger. |
| Field 9: Sum of all current drawn into one inverter/charger unit. |
| Field 10: AC input frequency |
|
|
STBY/ON Fault Clear | Press momentarily to clear all faults on all devices on the network. |
button | Press and hold for five seconds to switch all devices in the network |
| between operating and safe modes. |
|
|
Enter, Up arrow, | Switches between Basic Settings and Advanced Settings. |
Down arrow buttons |
|
(pressed |
|
simultaneously) |
|
|
|
Table 3 Device Setup Screen Status Information
Line 1
Line 2
Line 3
Label: “FSW3012 00: Setup”
Label: Mode
Field 1: Freedom SW operating mode or “operating state” (see Table 4 on page 27).
Label: Battery
Field 2: Total battery current. Negative value if the battery is discharging and positive value when charging.
Field 3: Battery voltage
Field 4: Battery temperature. Displays the highest temperature when reading multiple inverters that are installed. Displays N/A when there is no BTS attached.
|
| 26 |
|
| Freedom SW Owner’s Guide |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|