Xerox 8265, 8290 Controlling the Heater Elements, Setup items, Key name, Parameters, Description

4 Printer Operation

Step 4 : Press the [F3] key or the [F4] key on the operation panel.

I)The product will perform following operations:

Setup items	Key name	Parameters
Cut & Feed	F3	Forward
	F4	Backward

Notes

Description

Feeds media forward. Feeds media backward.

If "Take-Up Roll" is set in the media detection setup menu, the product will not operate even if the [F4] key has been pressed.

4.4.2Controlling the Heater Elements

If you want to change or check the heater elements, follow the steps below.

Step 1 : Verify the following regarding the condition of the printer.

I)It is not currently printing

Step 2 : Press the [F3] key of the operation panel.

I)To shift to the heater menu.

The ‘heater message’ can be one of the following:

oHeater standby

oHeater warming up o Heater ready

‘A’ stands for the heater. ‘B’ stands for the fixer.

‘C’ stands for the post fixer. ‘D’ stands for the dryer.

‘S’ stands for the Set-temperature (requested temperature).

‘R’ stands for the Real-temperature (actual temperature).

4.4.2.1Change the heater temperature

To change the temperature of the heater, press the [F1] key on the operation panel. The display will mention the following:

Press the [F2] key to decrease the temperature. Press the [F4] key to increase the temperature.

Press the [ENTER] key to confirm the requested temperature change.

Press the [CANCEL] key to leave the menu without changing the heater settings.

8265/8290/8365/8390 User Guide 85