4 Printer Operation
Step 3 : Change the value of one or more heaters or turn them all off.
Notes 
For more details about heater adjustment, please refer to “Controlling the heater elements on the 8265/8290/8365/8390 printer”
4.6OPERATIONS AFTER PRINTING
4.6.1Cutting Media
The media cutting procedure is described below. Roll media is automatically cut after printing when "Auto" is set on the cut media menu and roll media has been set. When the operation panel is in the normal status, and the product is in the following conditions, the media can be cut on the desired position:
•When roll media has been set:
•If "OFF" is set on the cut media menu
•If "Take Up Roll" has been set in the media detection setup menu
•When sheet media has been set
Step 1 : Make sure that the MEDIA SET lamp on the operation panel is off.
Step 2 : Press the [F1] key on the operation panel.
Step 3 : Press the [F3] key on the operation panel to feed media to the desired position according to the procedure in "Feeding media".
*Cut&Feed*
Cut Dist.Adj Forward Backward
Step 4 : Press the [F1] key on the operation panel.
I)The media is cut at its position when the [ENTER] key has been pressed.
Notes 
If the front edge of the roll media is not straight when you load new roll media, you should cut its edge. Cutting blades are consumable. Replace them at regular intervals following "Replacing the cutting blade".
90 | 8265/8290/8365/8390 User Guide |
