Getting started
Using the remote control
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote control sensor on this unit during operation.
Remote control sensor
Notes
•Do not spill water or other liquids on the remote control.
•Do not drop the remote control.
•Do not leave or store the remote control in the following types of conditions:
–places of high humidity, such as near a bath
–places of high temperatures, such as near a heater or stove
–places of extremely low temperatures
–dusty places
Approximately | 30 | 30 |
6 m (20 ft) |
6LIGHT
Lights up the remote control buttons and the display window (4).
Display window (4)
[1] [2]
ZONE 4
[3][4]
[1]ID1/ID2 indicator
Indicates the currently selected remote control ID (see page 119).
[2] Transmit indicator
Appears while the remote control is sending infrared signals.
[3] Zone indicators
Indicates the currently controlling zone (see page 116).
[4] Information display
Shows the name of the selected input source that you can control.
Infrared window (1)
Outputs infrared control signals. Aim this window at the component you want to operate.
Operation mode selector (F)
The function of some buttons depends on the operation mode selector position.
Backlight mode
The remote control is equipped with the motion sensor and the remote control lights up the backlight corresponding to the motions or operation. If you do not want to lights up the backlight when this unit detects motions, change the backlight mode (see page 104).
Opening and closing the front panel door
When you want to use the controls behind the front panel door, open the door by gently pressing on the lower part of the panel. Keep the door closed when not using these controls.
To open, press gently on the lower part of the panel.
VOLTAGE SELECTOR
(Asia and General models only)
Caution
The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.
Voltages are as follows:
...................... AC
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input selector button (see page 103).
TV
Operates the TV (see page 102).
VOLTAGE |
SELECTOR |
230- |
240V |
Voltage indication
