Yamaha DSP-Z11 Loading the stored system settings, 98 En, Saved parameters for the main zone

Saving and recalling the system settings (System Memory)

■Saved parameters for the main zone

The groups of the system parameters indicated in bold are the groups that is saved in the initial setting.

Group	Parameters	Page
Input/HDMI	Audio Select	82
Out *
	Decoder Mode	82
	Input source	50
	HDMI OUT SEL	—
Audio	Stereo/Surround	77
	Pure Direct on/off	61
	EXTD SUR. setting	72
	Adaptive DRC	86
	Adaptive DSP Lvl	86
	LFE Level	86
	Dynamic Range	87
	Tone Control	88
	Pure Direct	89
	CINEMA DSP HD³ ON/OFF	60
Volume	Volume level	50
SP Config	S-Wave Control	87
	Parametric EQ	87
	THX Set	83
	Speaker Set	84
	Speaker Distance	85
	Speaker Level	86
	Speaker B	91
	Information (Auto Setup)	45
	Setup Menu (Auto Setup)	44
	Selected front speaker set (A and/or B)	51
Video	Conversion	89
	HDMI Processing	90
	Component I/P	90
	HDMI Resolution	90
	HDMI Aspect	90
	Short Message	90
	On Screen	90
	Position	90
	Wall Paper	91
Option	Lipsync	88
	Front Panel Disp.	93
	Support Audio	94

Note

*The playing status of the network/USB sources (selected radio station, etc.) is also saved.

■Saved parameters for Zone 2, Zone 3, or Zone 4

Parameter	Descriptions	Page
Input	Input source *	117
Volume	Volume level	117
Tone Control	Tone control settings	117

Note

*The playing status of the network/USB sources (selected radio station, etc.) is also saved.

Loading the stored system settings

•Before performing the following operations, set the operation mode selector on the remote control to FAMP.

•This unit overwrites the stored settings to the current settings of this unit. If you do not want to erase the current settings, save the current settings to any System Memory number in advance.

■Loading by the 7SYSTEM MEMORY buttons

You can recall the system settings stored in “Memory1” to “Memory4” by pressing the corresponding 7SYSTEM MEMORY buttons.

y

To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE on the remote control repeatedly to select the operation zone setting of the remote control in advance. You can recall the system settings for the selected zone only when the zone is turned on.

1Press one of the 7SYSTEM MEMORY buttons on the remote control to select the desired memory number.

“MEMORY 1 LOAD” (example) appears in the front panel display.

y

“EMPTY” appears in the menu screen if no system settings are stored in the selected memory number.

2Press the selected 7SYSTEM MEMORY button once more to confirm the selection.

This unit loads the settings stored in the selected memory number.

■Loading by the GUI menu operation

1Press IMENU on the remote control.

The top menu appears in the video monitor.

2Press 9k / n repeatedly to select “System Memory” and then press 9h.

The “System Memory” menu appears in the video monitor.

3Press 9k / n repeatedly to select the desired zone and then press 9h.

In the following example, you select “Main” (main zone). The list of the memory number appears in the video monitor.

Main Load	Memory1
Main Save	Memory2
Main Rename	Memory3

98 En