Yamaha DSP-Z11 owner manual Connecting the network, 37 En, Notes, Preparation

Connections

Connecting the network

To connect this unit to your network, plug one end of a network cable (CAT-5 or higher straight cable) into the NETWORK port on this unit, and plug the other end into one of the LAN ports on your router that supports the DHCP (Dynamic Host Configuration Protocol) server function. The following diagram shows a connection example where this unit is connected to one of the LAN ports on a 4-port router. To enjoy music files saved on your PC and Yamaha MCX-2000, access the Internet Radio, or control this unit by using your PC, each device must be connected properly in the network.

Notes

•You must use an STP (shielded twisted pair) cable (commercially available) to connect a network hub or router and this unit.

•If the DHCP server function on your router is disabled, you need to configure the network settings manually (see page 92).

•Yamaha MCX-2000, MCX-A10 and MCX-C15 may not be for sale in same locations.

Internet		Yamaha MCX-2000
			Yamaha MCX-C15
	WAN	Yamaha MCX-A10
		(with optional
		speakers)	PC
	LAN

Modem

Router

Network cable

NETWORK

Preparation

Connecting the USB storage devices to the USB ports

This unit is equipped with both the front and rear USB ports. Connect the USB storage device (for example, a high capacity USB hard disk drive) to the front or rear USB port on this unit. Set “USB Select” in “Input Select” to “Front” or “Rear” to select the active USB port (see page 83). The initial setting of “USB Select” is “Front”. The initial setting of “USB Select” is “Front”.

(Rear panel)	(Front panel)
USB
T/	TONE CONTROL
2

PUSH ENTER

L HDMI IN USB

USB storage device

USB storage device or USB portable audio player

Notes

•We do not guarantee the power supply and operation of all the connected USB devices.

•See page 69 for more information about the USB storage devices that this unit is supported to.

37 En