Yamaha DSP-Z11 owner manual Connecting the speaker cable, 27 En, Using bi-amplificationconnections

Connecting the speaker cable

1Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits.

10 mm (0.4 in)

2Loosen the knob.

Red line: positive (+)

White line: negative (–)

3Insert one bare wire into the hole on the side of each terminal.

Connections

■Connecting the banana plug (China and General models only)

Tighten the knob and then insert the banana plug connector into the end of the corresponding terminal.

banana plug

Preparation

Red line: positive (+)

White line: negative (–)

■Using bi-amplification connections

Caution

Remove the shorting bars or bridges of your speakers to separate the LPF (low pass filter) and HPF (high pass filter) crossovers.

This unit allows you to make bi-amplification connections to one speaker system. Check if your speakers support bi-amplification. To make the bi-amplification connections, use the FRONT A and SUR.BACK/BI-AMP terminals as shown below. To activate the bi- amplification connections, set “BI-AMP”to “ON” in “Advanced setup” (see page 120).

This unit

4Tighten the knob to secure the wire.

+	R	L	+
			(SINGLE)
SUR. BACK/			SUR. BACK/
BI-AMP			BI-AMP

B	B
	FRONT B/
FRONT B/
	ZONE
ZONE
EXTRA SP	EXTRA SP
	FRONT B/
A	A
FRONT A	FRONT A

Right Left

Front speakers

Note

When you make the conventional connection, make sure that the shorting bars are put into the terminals of the speakers appropriately. Refer to the instruction manuals of the speakers for details.

27 En