ZyXEL Communications 480 manual Callback Budget Management Allocated Budget

Prestige 480 Dual BRI ISDN Router

Callback Budget
Management:
Allocated Budget	This field sets the budget callback time for all the remote dial-in users.	Default = 0
(min)	The default for this field is 0 for no budget control.
Period (hr)	This field sets the time interval to reset the above callback budget
	control.
IP Address
Supplied By:
Dial-in User	If set to Yes, the Prestige will allow a remote host to specify its own IP	(Default =
	address.	Yes)
	If set to No, the remote host must use the IP address assigned by your	Yes/No
	Prestige from the IP pool, configured below. This is to prevent the
	remote host from using an invalid IP address and potentially disrupting
	the whole network.
IP Pool	This field tells your Prestige to provide the remote host with an IP	Yes/No
	address from the pool. This field is required if IP Address Supplied	(Default =
	By: Dial-in User is set to No. You can configure this field even if Dial-
		No)
	in User is set to Yes, in which case your Prestige will accept the IP
	address if the remote peer specifies one; otherwise, an IP address is
	assigned from the pool.
IP Pool: IP Start	This field is applicable only if you selected Yes in the Dial-In IP
Addr	Address Supplied By: IP Pool field.
	The IP pool contains contiguous IP addresses and this field specifies
	the first one in the pool.
IP Count (1,4)	In this field, enter the number (1 or 4,) of addresses in the IP Pool. For	1, 4
	example, if the starting address is 192.168.135.5 and the count is 4,
	then the pool will have 192.68.135.5 and 192.68.135.8
Session Options:	Press Yes, then [Enter] to edit the filter sets. Keep in mind that the
Edit Filter	filter set(s) will only apply to remote dial-in users but not the remote
	nodes.
Sets
	Note that spaces and [-] symbol, are accepted in this field. For more
	information on customizing your filter sets, see Chapter 9 - Filter
	Configuration. The default is blank, i.e., no filters.

Once you have completed filling in Menu 13 - Default Dial-in Setup, press [Enter] at the message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to cancel.

8-6 Dial-In Server Configuration