ZyXEL Communications 480 Additional Installation Requirements, Housing, Power On Your Prestige

Prestige 480 Dual BRI ISDN Router

Note: You cannot access the PNC if you use the RS232 cable. You must use only the Ethernet cable.

2.4Additional Installation Requirements

In addition to the contents of your package, there are other hardware and software requirements you need before you can install and use your Prestige. These requirements include:

1.A computer with Ethernet 10Base-T NIC (Network Interface Card).

2.A computer equipped with communications software configured to the following parameters:

♦VT100 terminal emulation.

♦9600 Baud.

♦No parity, 8 Data bits, 1 Stop bit.

2.5Housing

Your Prestige's housing has ventilation slots for cooling and clip -out legs that fit snugly into grooves for sturdy stacking with better airflow. ZyXEL recommends that you do not stack more than 4 routers for maximum stack stability and cooling.

2.6Power On Your Prestige

At this point, you should have connected the console port, the ISDN BRI port, the Ethernet port and the power port to the appropriate devices or lines.

Step 1. Initial Screen

When you power on your Prestige, it performs several internal tests as well as line initialization. After the initialization, the Prestige asks you to press [Enter] to continue, as shown.

2-4

Copyright (c) 1994 - 1999 ZyXEL Communications Corp.

initialize ch =0, ethernet address: 00:a0:c5:ff:00:35

(2)DSS1:

(2)DSS1:

and Setup