ZyXEL Communications 480 manual TCP/IP Remote Node Configuration, Only /Out Only

Prestige 480 Dual BRI ISDN Router

The next table shows the TCP/IP related fields in Menu 11.3 - Remote Node Network Layer Options .

	Table 5-2 TCP/IP Remote Node Configuration
Rem IP	This will show the IP address you entered for this remote node in the
Address	previous menu.
Rem IP	Enter the subnet mask for the remote network.
Subnet
Mask
My WAN	Some implementations, especially the UNIX derivatives, require the ISDN
Addr	link to have a separate IP network number from the LAN and each end
	must have a unique address within the WAN network number. If this is the
	case, enter the IP address assigned to the ISDN port of your Prestige.
	Note that this is the address assigned to your local Prestige, not the
	remote router.
Single	Set this field to Yes to enable the Single User Account feature for your	Yes/No
User	Prestige. Use the space bar to toggle between Yes and No. See Chapter
Account	3 - Internet Access Application for more information on the Single User
	Account feature.
Metric	The metric represents the “cost” of transmission for routing purposes. IP	1 to 15
	routing uses hop count as the measurement of cost, with a minimum of 1
	for directly connected networks. Enter a number that approximates the
	cost for this link. The number need not be precise, but it must be between
	1 and 15. In practice, 2 or 3 is usually a good number.
Private	This parameter determines if the Prestige will include the route to this	Yes/No
	remote node in its RIP broadcasts. If set to Yes, this route is kept private
	and not included in RIP broadcast. If No, the route to this remote node will
	be propagated to other hosts through RIP broadcasts.
RIP	Press the space bar to select the RIP direction from Both/ None/In	(Default=Both)
	Only/Out Only.
Version=	Press the space bar to select the RIP version from RIP-1/RIP-2B/RIP-2M.	RIP-1(default)

Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to Menu 11. Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.

Remote Node TCP/IP Configuration 5-5