Prestige 480 Dual BRI ISDN Router

Figure 2-15 Menu 2.2 - NetCAPI Setup

Step 2. Set the fields in the above menu according to the following description.

 

Table 2-7 NetCAPI Setup Fields

 

 

Field

Description

Active

This field allows you to enable or disable NetCAPI. Press the [Spacebar] to toggle

 

between Yes and No

Max Number of

When you want to use NetCAPI to place outgoing calls or to listen to incoming calls,

Registered Users

you must start RVSCOM on your workstation, and RVSCOM will register itself to the

 

Prestige. This option is the maximum number of clients that the Prestige supports at the

 

same time. The default value is 4.

Incoming Data

This field determines how incoming calls are routed. Press the [Spacebar] to select

Call Matching

NetCAPI if you want to direct all incoming data calls to NetCAPI.

 

Select MSN if you want to direct all incoming call to the Prestige only when the

 

incoming phone number matches the ISDN DATA number in Menu 2. If the incoming

 

phone number does not match the ISDN DATA number, then the call will be routed to

 

NetCAPI.

 

Select Called Party Subaddress if you want to direct all incoming calls to the Prestige

 

only when the incoming call matches the subaddress of ISDN DATA in Menu 2. If the

 

incoming call does not match the subaddress of ISDN DATA, then the call will be routed

 

to NetCAPI.

Access List

This list specifies users that can use NetCAPI. This access list controls if a client is

 

allowed to use NetCAPI. The request is rejected when

 

1. The IP address of the workstation is not between Start IP and End IP or

 

2. The request from the workstation is not permitted as specified in the

 

Operation field.

Start IP

Refers to the first IP address of a group of NetCAPI clients. Each group contains

 

contiguous IP addresses.

End IP

Refers to the last IP address in a NetCAPI client group.

Operation

Press the [Spacebar] to select Incoming if you wish to grant incoming calls permission.

 

Select Outgoing if you wish to grant outgoing calls permission. Select

 

Both if you wish to grant both incoming calls and outgoing calls permissions. Select

 

None if you wish to deny all calls.

2-20

Hardware Installation and Setup

Page 60
Image 60
ZyXEL Communications 480 manual NetCAPI Setup Fields, Operation field