Chapter 11 Spanning Tree Protocol
11.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 11.1 on page 109 for more information on RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 52 Advanced Application > Spanning Tree Protocol > RSTP
The following table describes the labels in this screen.
Table 26 Advanced Application > Spanning Tree Protocol > RSTP
LABEL | DESCRIPTION |
Status | Click Status to display the RSTP Status screen (see Figure 53 on page 118). |
|
|
Active | Select this check box to activate RSTP. Clear this checkbox to disable RSTP. |
| Note: You must also activate Rapid Spanning Tree in the |
| Advanced Application > Spanning Tree Protocol > |
| Configuration screen to enable RSTP on the Switch. |
|
|
116 |
| |
| ||
|
|
|