Chapter 45 Introducing Commands
•9600 bps
•No parity
•8 data bits
•1 stop bit
•No flow control
45.2.1.1Initial Screen
When you turn on your Switch, it performs several internal tests as well as line initialization. You can view the initialization information using the console port. After the initialization, the login screen displays (refer to Section 45.3 on page 332).
Copyright (c) 1994 - 2007 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:13:49:00:00:01
initialize switch, ethernet address: 00:13:49:00:00:02
Initializing switch unit 0...
Initializing MSTP.............
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Press ENTER to continue...
Use the following steps to telnet into your Switch.
1For local management, connect your computer to the
2Make sure your computer IP address and the Switch IP address are on the same subnet. In Windows, click Start (usually in the bottom left corner), Run and then type telnet 192.168.0.1 (the default management IP address) and click OK.
3A login screen displays (refer to Section 45.3 on page 332).
45.3The Login Screen
After you have successfully established a connection to the Switch using a direct console connection or Telnet, a login screen displays as shown below. For your first login, enter the default administrator login username “admin” and password “1234”.
Enter User Name : admin
Enter Password : XXXX
45.4 Command Syntax Conventions
The rules of the commands are listed next.
• The command keywords are in courier new font.
332 |
| |
| ||
|
|
|