Chapter 48 Interface Commands

•Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the Switch.

•Enable ports one, three, four and five for configuration.

•Enable GVRP on the interface.

sysname(config)# vlan1q gvrp sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# gvrp

48.2.8 ingress-check

The ingress-checkcommand enables the device to discard incoming frames for VLANs that do not have this port as a member.

Syntax:

ingress-check

An example is shown next.

•Enable ports 1, 3, 4 and 5 for configuration.

•Enable ingress checking on the interface.

sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# ingress-check

48.2.9 frame-type

Syntax:

frame-type <alltagged> where

<alltagged> = Choose to accept both tagged and untagged incoming frames or just tagged incoming frames on a port.

An example is shown next.

•Enable ports one, three, four and five for configuration.

•Enable ingress checking on the ports.

•Enable tagged frame-types on the interface.

sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# ingress-check sysname(config-interface)# frame-type tagged

48.2.10 weight

Syntax:

weight <wt1> <wt2> ... <wt8>

408

 

ES-4124 User’s Guide