ZyXEL Communications ES-4124 manual 381

Chapter 45 Introducing Commands

Use these commands to configure the IP routing domains.

Table 143 interface route-domain Commands

COMMAND			DESCRIPTION	PRIVILEG
				E
interface			Enables a routing domain for	13
route-domain			configuration.
<ip-address>/
<mask-bits>
	exit		Exits from the interface routing-	13
			domain command mode.
	ip	dvmrp	Enables this function to permit	13
			VLAN groups beyond the local
			Switch.
		igmp <v1v2v3>	Enables IGMP in this routing	13
			domain and specifies the version
			of the IGMP packets that the
			Switch should use.
		igmp robustness-	Sets the igmp robustness	13
		variable <2-255>	variable on the Switch. This
			variable specifies how
			susceptible the subnet is to lost
			packets.
		igmp query-interval	Sets the igmp query interval on	13
			the Switch. This variable
			specifies the amount of time in
			seconds between general query
			messages sent by the router.
		igmp query-max-	Sets the maximum time that the	13
		response-time <1-25>	router waits for a response to an
			general query message.
		igmp last-member-	Sets the amount of time in	13
		query-interval <1-25>	seconds that the router waits for
			a response to a group specific
			query message.
		ospf authentication-	Enables OSPF authentication in	13
		key <k>	this routing domain.
		ospf authentication-	Sets the same OSPF	13
		same-aa	authentication settings in the
			routing domain as the associated
			area.
		ospf cost <1-65535>	Sets the OSPF cost in this	13
			routing domain.
		ospf message-digest-	Sets the OSPF authentication	13
		key <k>	key in this routing domain.
		ospf priority <0-255>	Sets the OSPF priority for the	13
			interface. Setting this value to 0
			means that this router will not
			participate in router elections.
		rip direction	Sets the RIP direction in this	13
		<OutgoingIn>	routing domain.
		vrrp authentication-	Sets the VRRP authentication	13
		key <k>	key in the routing domain.

	381
ES-4124 User’s Guide