Chapter 45 Introducing Commands

Table 141

Command Summary: Configuration Mode (continued)

 

COMMAND

 

 

 

DESCRIPTION

PRIVILEGE

 

 

<SPTPID>

 

Sets the SP TPID (Service

13

 

 

 

 

Provider Tag Protocol Identifier).

 

vlan-type

 

<802.1qport-

 

Specifies the VLAN type.

13

 

 

based>

 

 

 

wfq

 

 

 

Sets the queuing method to

13

 

 

 

 

WFQ (Weighted Fair Queuing).

 

wrr

 

 

 

Sets the queuing method to

13

 

 

 

 

WRR (Weighted Round Robin).

 

45.12.4 interface port-channel Commands

The following table lists the interface port-channelcommands in configuration mode. Use these commands to configure the ports.

Table 142 interface port-channel Commands

COMMAND

 

DESCRIPTION

PRIVILEGE

interface

 

 

Enables a port or a list of ports for

13

port-

 

 

configuration.

 

channel

 

 

 

 

<port-

 

 

 

 

list>

 

 

 

 

 

arp inspection

trust

Sets the port to be a trusted port

13

 

 

 

for arp inspection. The Switch

 

 

 

 

does not discard ARP packets on

 

 

 

 

trusted ports for any reason.

 

 

 

 

 

 

 

 

limit rate <pps>

Specifies the maximum rate (1-

13

 

 

 

2048 packets per second) at

 

 

 

 

which the Switch receives ARP

 

 

 

 

packets from each port. The

 

 

 

 

Switch discards any additional

 

 

 

 

ARP packets. Enter 0 to disable

 

 

 

 

this limit.

 

 

 

 

 

 

 

 

limit rate <pps>

Specifies the length (1-15

13

 

 

burst interval

seconds) of the burst interval.

 

 

 

<seconds>

The burst interval is the length of

 

 

 

 

time over which the rate of ARP

 

 

 

 

packets is monitored for each

 

 

 

 

port.

 

 

 

 

 

 

 

bandwidth-limit

 

Enables ingress (pir), cir and

13

 

 

 

egress limits on the port(s).

 

 

 

cir

Enables the guaranteed

13

 

 

 

bandwidth limits for incoming

 

 

 

 

traffic on the port(s).

 

 

 

 

 

 

 

 

cir <Kbps>

Sets the guaranteed bandwidth

13

 

 

 

allowed for incoming traffic on the

 

 

 

 

port(s).

 

 

 

 

 

 

 

 

pir

Enables bandwidth limits allowed

13

 

 

 

for incoming traffic on the port(s).

 

 

 

pir <Kbps>

Sets the maximum bandwidth

13

 

 

 

allowed for incoming traffic on the

 

 

 

 

port(s).

 

 

 

 

 

 

 

375

ES-4124 User’s Guide