Chapter 45 Introducing Commands
Table 142 interface
COMMAND | DESCRIPTION | PRIVILEGE | ||
|
| egress | Enables bandwidth limits allowed | 13 |
|
|
| for outgoing traffic on the port(s). |
|
|
| egress <Kbps> | Sets the maximum bandwidth | 13 |
|
|
| allowed for outgoing traffic on the |
|
|
|
| port(s). |
|
|
|
|
|
|
|
| Sets how Bridge Protocol Data | 13 | |
| <peertunneldisc |
| Units (BPDUs) are used in STP |
|
| ardnetwork> |
| port states. |
|
|
| Enables broadcast storm control | 13 | |
|
|
| limit on the Switch. |
|
|
| <pkt/s> | Specifies the maximum number | 13 |
|
|
| of broadcast packets allowed to |
|
|
|
| pass through this port per |
|
|
|
| second. Broadcast packets |
|
|
|
| above this threshold are dropped |
|
|
|
| by the Switch. |
|
|
|
|
|
|
| dhcp snooping |
| Sets this port as a trusted DHCP | 13 |
| trust |
| snooping port. Trusted ports are |
|
|
|
| connected to DHCP servers or |
|
|
|
| other switches, and the Switch |
|
|
|
| discards DHCP packets from |
|
|
|
| trusted ports only if the rate at |
|
|
|
| which DHCP packets arrive is too |
|
|
|
| high. |
|
|
|
|
|
|
| dhcp snooping |
| Sets the maximum rate that | 13 |
| limit rate <pps> |
| DHCP packets are allowed to |
|
|
|
| arrive at a trusted DHCP |
|
|
|
| snooping port. |
|
|
|
|
|
|
| diffserv |
| Enables DiffServ on the port(s). | 13 |
|
| Enables the Destination Lookup | 13 | |
|
|
| Failure (DLF) limit. |
|
|
| <pkt/s> | Sets the interface DLF limit in | 13 |
|
|
| packets per second (pps). |
|
| egress set <port- |
| Sets the outgoing traffic port list | 13 |
| list> |
| for a |
|
| ethernet oam |
| Enables Ethernet OAM on the | 13 |
|
|
| port(s). |
|
|
| mode | Specifies active or passive OAM | 13 |
|
| <activepassive> | mode on the ports. Active mode |
|
|
|
| allows the port to issue remote |
|
|
|
| loopback and discovery |
|
|
|
| commands. Passive mode |
|
|
|
| means that the port can only |
|
|
|
| respond to Ethernet OAM |
|
|
|
| commands. |
|
|
|
|
|
|
|
| Enable Ethernet OAM remote- | 13 | |
|
| supported | loopback capability on the |
|
|
|
| port(s). |
|
| exit |
| Exits from the interface port- | 13 |
|
|
| channel command mode. |
|
376 |
| |
| ||
|
|
|