ZyXEL Communications ES-4124 manual 396

Chapter 47 Configuration Mode Commands

where
<T1T2T3T4T5T6>	= Disables the trunk group.
<T1T2T3T4T5T6>	= Disables LACP in the trunk group.
lacp
<T1T2T3T4T5T6>	= Removes ports from the trunk group.
interface <port-list>

An example is shown next.

•Disable trunk one (T1).

•Disable LAPC on trunk three (T3).

•Remove ports one, three, four and five from trunk two (T2).

sysname(config)# no trunk T1 sysname(config)# no trunk T3 lacp sysname(config)# no trunk T2 interface 1,3-5

47.4.4.2no port-access-authenticator

Syntax:

no port-access-authenticator

no port-access-authenticator <port-list> reauthenticate no port-access-authenticator <port-list>

where

	= Disables port authentication on the Switch.
<port-list>	=	Disables the re-authentication mechanism on the listed port(s).
reauthenticate
<port-list>	=	Disables authentication on the listed ports.

An example is shown next.

•Disable authentication on the Switch.

•Disable re-authentication on ports one, three, four and five.

•Disable authentication on ports one, six and seven.

Figure 203 no port-access-authenticator Command Example

sysname(config)# no port-access-authenticator

sysname(config)# no port-access-authenticator 1,3-5 reauthenticate sysname(config)# no port-access-authenticator 1,6-7

47.4.4.3no ssh

Syntax:

no ssh key <rsa1rsadsa> no ssh known-hosts <host-ip>

no ssh known-hosts <host-ip> [1024ssh-rsassh-dsa]

396
	ES-4124 User’s Guide