Chapter 49 IEEE 802.1Q Tagged VLAN Commands
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave All Timer to 11000 milliseconds.
sysname (config)# garp join 300 leave 800 leaveall 11000
49.2.3 GVRP Timer
Syntax:
show vlan1q gvrp
This command shows the Switch’s GVRP settings.
An example is shown next.
sysname# show vlan1q gvrp GVRP Support
gvrpEnable = YES sysname #
49.2.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the Switch.
49.2.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the Switch does not propagate VLAN information to other switches.
49.3 Port VLAN Commands
You must configure the Switch port VLAN settings in
49.3.1 Set Port VID
Syntax:
pvid <VID>
where
<VID> | = Specifies the VLAN number between 1 and 4094. |
This command sets the default VLAN ID on the port(s).
| 415 |
|
|