|
| Chapter 10 Quality of Service (QoS) | |
| Table 34 Class Setup: Add/Edit | ||
| LABEL | DESCRIPTION |
|
| MAC Mask | Type the mask for the specified MAC address to determine which bits |
|
|
| a packet’s MAC address should match. |
|
|
| Enter “f” for each bit of the specified source MAC address that the |
|
|
| traffic’s MAC address should match. Enter “0” for the bit(s) of the |
|
|
| matched traffic’s MAC address, which can be of any hexadecimal |
|
|
| character(s). For example, if you set the MAC address to |
|
|
| 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a |
|
|
| MAC address of 00:13:49:12:34:56 matches this criteria. |
|
|
|
|
|
| Exclude | Select this option to exclude the packets that match the specified |
|
|
| criteria from this classifier. |
|
|
|
|
|
| Others |
|
|
|
|
|
|
| Service | This field is available only when you select IP in the Ether Type field. |
|
|
| This field simplifies classifier configuration by allowing you to select a |
|
|
| predefined application. When you select a predefined application, you |
|
|
| do not configure the rest of the filter fields. |
|
|
|
|
|
| IP Protocol | This field is available only when you select IP in the Ether Type field. |
|
|
| Select this option and select the protocol (service type) from TCP, |
|
|
| UDP, ICMP or IGMP. If you select User defined, enter the protocol |
|
|
| (service type) number. |
|
|
|
|
|
| DHCP | This field is available only when you select IP in the Ether Type field. |
|
|
| Select this option and select a DHCP option. |
|
|
| If you select Vendor Class ID (DHCP Option 60), enter the Vendor |
|
|
| Class Identifier (Option 60) of the matched traffic, such as the type of |
|
|
| the hardware or firmware. |
|
|
| If you select User Class ID (DHCP Option 77), enter a string that |
|
|
| identifies the user’s category or application type in the matched DHCP |
|
|
| packets. |
|
|
|
|
|
| Packet Length | This field is available only when you select IP in the Ether Type field. |
|
|
| Select this option and enter the minimum and maximum packet |
|
|
| length (from 46 to 1500) in the fields provided. |
|
|
|
|
|
| DSCP | This field is available only when you select IP in the Ether Type field. |
|
|
| Select this option and specify a DSCP (DiffServ Code Point) number |
|
|
| between 0 and 63 in the field provided. |
|
|
|
|
|
| 802.1P | This field is available only when you select 802.1Q in the Ether Type |
|
|
| field. |
|
|
| Select this option and select a priority level (between 0 and 7) from |
|
|
| the |
|
|
| "0" is the lowest priority level and "7" is the highest. |
|
|
|
|
|
| VLAN ID | This field is available only when you select 802.1Q in the Ether Type |
|
|
| field. |
|
|
| Select this option and specify a VLAN ID number. |
|
|
|
|
|
| 161 |
|
|