Chapter 13 Spanning Tree Protocol
The following table describes the labels in this screen.
Table 28 Advanced Application > Spanning Tree Protocol > Configuration
LABEL | DESCRIPTION |
Spanning Tree | You can activate one of the STP modes on the Switch. |
Mode | Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or |
| |
| Multiple Spanning Tree. See Section 13.1 on page 147 for |
| background information on STP. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 13.1 on page 147 for more information on RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 63 Advanced Application > Spanning Tree Protocol > RSTP
154 |
| |
| ||
|
|
|