ZyXEL Communications 4528F, 4728F, XGS-4526 40.4.1 Configuring DSCP Settings

Chapter 40 Differentiated Services

To change the DSCP-IEEE 802.1p mapping, click the DSCP Setting link in the DiffServ screen to display the screen as shown next.

Figure 184 IP Application > DiffServ > DSCP Setting

The following table describes the labels in this screen.

Table 129 IP Application > DiffServ > DSCP Setting

LABEL	DESCRIPTION
0 … 63	This is the DSCP classification identification number.
	To set the IEEE 802.1p priority mapping, select the priority level from the drop-
	down list box.

Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch
	loses these changes if it is turned off or loses power, so use the Save link on
	the top navigation panel to save your changes to the non-volatile memory
	when you are done configuring.

Cancel	Click Cancel to begin configuring this screen afresh.