Chapter 17 Link Aggregation

1Make your physical connections - make sure that the ports that you want to belong to the trunk group are connected to the same destination. The following figure shows ports 2-5 on switch A connected to switch B.

Figure 76 Trunking Example - Physical Connections

B

A

2Configure static trunking - Click Advanced Application > Link Aggregation > Link Aggregation Setting. In this screen activate trunk group T1, select the traffic distribution algorithm used by this group and select the ports that should belong to this group as shown in the figure below. Click Apply when you are done.

Figure 77 Trunking Example - Configuration Screen

EXAMPLE

Your trunk group 1 (T1) configuration is now complete.

 

185

XGS-4526/4528F/4728F User’s Guide