Chapter 37 OSPF

To configure an area, set the related fields in the OSPF Configuration screen.

Figure 163 IP Application > OSPF Configuration: Area Setup

The following table describes the related labels in this screen.

Table 118 IP Application > OSPF Configuration: Area Setup

LABEL

DESCRIPTION

Name

Enter a descriptive name (up to 32 printable ASCII characters) for

 

identification purposes.

 

 

Area ID

Enter a 32-bit ID (that uses the format of an IP address in dotted decimal

 

notation) that uniquely identifies an area.

 

A value of 0.0.0.0 indicates that this is a backbone (also known as Area 0).

 

You can create only one backbone area on the Switch.

 

 

Authenticati

Select an authentication method (Simple or MD5) to activate

on

authentication. Select None (default) to disable authentication.

 

Usually interface(s) and virtual interface(s) should use the same

 

authentication method as the associated area. If interface(s) and virtual

 

interface(s) use different authentication methods than the associated area,

 

the authentication methods are based on the interface(s) and virtual

 

interface(s) settings.

 

 

Stub

Select this option to set the area as a stub area.

Network

If you enter 0.0.0.0 in the Area ID field, the settings in the Stub Area

 

 

fields are ignored.

 

 

No

Select this option to set the Switch to not send/receive LSAs.

Summary

 

 

 

Default

Specify a cost (between 0 and 16777215) used to add a default route into

Route

a stub area for routes which are external to an OSPF domain. If you do not

Cost

set a route cost, no default route is added.

 

 

 

338

 

XGS-4526/4528F/4728F User’s Guide