Chapter 17 Link Aggregation
When you enable LACP link aggregation on a port, the port can automatically negotiate with the ports at the remote end of a link to establish trunk groups. LACP also allows port redundancy, that is, if an operational port fails, then one of the “standby” ports become operational without user intervention. Please note that:
•You must connect all ports
•LACP only works on
•All ports in the same trunk group must have the same media type, speed, duplex mode and flow control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network topology loops.
17.2.1 Link Aggregation ID
LACP aggregation ID consists of the following information1:
Table 39 Link Aggregation ID: Local Switch
SYSTEM | MAC ADDRESS | KEY | PORT | PORT | |
PRIORITY | PRIORITY | NUMBER | |||
|
| ||||
0000 | 0000 | 00 | 0000 | ||
|
|
|
|
|
Table 40 Link Aggregation ID: Peer Switch
SYSTEM | MAC ADDRESS | KEY | PORT | PORT | |
PRIORITY | PRIORITY | NUMBER | |||
|
| ||||
0000 | 0000 | 00 | 0000 | ||
|
|
|
|
|
1.Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
178 |
| |
| ||
|
|
|