Chapter 27 Loop Guard

port N. The Switch will shut down port N if it detects that the probe packet has returned to the Switch.

Figure 132 Loop Guard - Network Loop

A

P

N

P

P

Note: After resolving the loop problem on your network you can re-activate the disabled port via the web configurator (see Section 8.7 on page 113) or via commands (see the Ethernet Switch CLI Reference Guide).

27.2 Loop Guard Setup

Click Advanced Application > Loop Guard in the navigation panel to display the screen as shown.

Note: The loop guard feature can not be enabled on the ports that have Spanning Tree Protocol (RSTP, MRSTP or MSTP) enabled.

Figure 133 Advanced Application > Loop Guard

 

285

XGS-4526/4528F/4728F User’s Guide